Combine Skin & Eye Set with LED Masks: Step by Step

Quick answer

Use the Nourishing Skin & Eye Therapy Set after your LED mask session to lock in hydration and boost firmness, or use the SkinSonic wand before the mask for deeper product penetration.

Step-by-step combination routine

1. Cleanse and prep: Start with a clean, dry face. Remove all makeup and sunscreen. Do not apply any serums or moisturizers yet. Checkpoint: LED light cannot penetrate through thick products, so bare skin is essential for this step.
2. Apply LED mask: Use your LED mask according to its instructions, typically for 10-20 minutes. Keep your eyes closed if the mask has eye coverage. Common mistake: Opening eyes during treatment can cause discomfort; always follow the mask's eye safety guidelines.
3. Use the SkinSonic wand with hydrating serum: After removing the LED mask, apply the hyaluronic acid activating serum from the Nourishing Skin & Eye Therapy Set. Glide the SkinSonic wand over your face in upward motions for 3-5 minutes. Checkpoint: Do not press too hard—let the ultrasonic vibrations do the work to avoid skin irritation.
4. Apply the Lift & Plump serum: Follow with the collagen and hyaluronic acid serum from the set. Gently pat it into the skin around your eyes, cheeks, and jawline. Common mistake: Rubbing the serum can disturb the LED-treated skin; use a tapping motion instead.
5. Finish with moisturizer: Seal everything with your regular moisturizer. This locks in the serums and the benefits of the LED therapy. Takeaway: Your skin is now primed for overnight recovery—skip any exfoliating acids or retinol on LED days.

Product spotlight

• Nourishing Skin & Eye Therapy Set: The SkinSonic uses ultrasonic skin-tightening technology to boost firmness and elasticity without damaging the skin. Using the SkinSonic before your LED mask helps the serums penetrate deeper, so the LED light can work on a more prepared skin surface.