Elevated Neck Tech + Beyond Set: Unboxing & Use Guide
By Empowering Your Skin Journey | LED Light Therapy | Published: 2026-10-26
Category: How-to Guides
Discover what’s inside the Elevated Neck Tech + Beyond Set and follow a step-by-step routine to use the LED face and neck device and instant age renewal wand for firmer, lifted skin.
Quick answer
The Elevated Neck Tech + Beyond Set combines the LumaLux Face+ LED device for face and neck with the Reva Instant Age Renewal Wand for targeted contouring. Use them in sequence after cleansing to stimulate collagen, lift contours, and boost product absorption.
Why combine LED therapy with a contouring wand
LED light therapy works best when skin is clean and receptive, and the Reva wand’s microcurrent-like action helps serums penetrate deeper. Using both in one session addresses collagen loss on the neck and facial definition at the same time — something a single device often can’t do.
What you get in the box
The set includes the LumaLux Face+ LED device (designed for face and neck), the Reva Instant Age Renewal Wand, a collagen-rich sheet mask, and a plumping serum. Each item targets a different layer of skin support, from surface hydration to deeper firming.
How to use the Elevated Neck Tech + Beyond Set
- 1. Cleanse and prep your skin: Remove all makeup and wash your face and neck with a gentle cleanser. Pat dry. Apply a thin layer of the plumping serum from the set — this helps the LED light conduct evenly and prevents dryness. Don’t skip the serum; bare skin can feel warm during LED use, and the serum acts as a buffer.
- 2. Use the LumaLux Face+ on your face and neck: Turn on the device and place it flat against your face, starting at the forehead. Hold for 3-5 minutes, then move to each cheek. Afterward, reposition the device on your neck, holding for 2-3 minutes on each side. The device will auto-shutoff after a session. Keep the device in contact with skin — lifting it mid-session reduces light exposure and won’t harm the device but wastes treatment time.
- 3. Apply the sheet mask (optional but recommended): After the LED session, unfold the collagen sheet mask and place it over your face. Leave it on for 10-15 minutes. This step locks in hydration while your skin is still warm from the light therapy. Don’t let the mask dry completely; remove it while it’s still damp to avoid pulling moisture from your skin.
- 4. Use the Reva Instant Age Renewal Wand: Remove the mask and gently rinse any excess. Apply a few drops of the plumping serum again. Turn on the wand and glide it upward along your jawline, cheekbones, and neck using slow, sweeping motions. Spend about 2 minutes per side. Always move the wand upward — downward strokes can counteract the lifting effect and may feel uncomfortable.
- 5. Finish with your regular moisturizer: Seal everything with a lightweight moisturizer or night cream. Avoid applying heavy oils immediately after the wand, as they can clog pores if not fully absorbed. Wait 1-2 minutes after the wand before applying moisturizer to let the serum fully absorb.
Product facts
- Elevated Neck Tech + Beyond Set: The LumaLux Face+ brings advanced LED therapy to both face and neck, stimulating collagen, softening lines, and reviving skin tone. You can treat two areas in one step, making the routine more time-efficient while still targeting the neck — a zone often neglected by standard LED masks.
Elevated Neck Tech + Beyond Set - Elevated Neck Tech + Beyond Set: The Reva Instant Age Renewal Wand adds targeted lift and contouring, enhancing product absorption and facial definition. Using the wand after LED helps push the plumping serum deeper into the skin, which can improve the visible lift around the jawline and cheeks.
